G.AL® Specialty Plates
optimized materials for applications with special demands
G.AL® C250 ELOX PLUS – a Cast Tool & Jig Plate meeting highest optical demands
Typically, Cast Tool & Jig Plate are made from the alloy EN AW-5083. While this alloy is great for meeting tight tolerances and has very little internal stresses, its anodization response is not always able to meet highest optical demands.
Our solution for this problem: G.AL® ELOX PLUS!
G.AL® DYNAMIC – the optimized material for applications under dynamic loads – increases the service life up to 40 times.
Component failure due to the formation of fatigue cracks in the material is a common problem that has come into the focus of design engineers because of increasing competitive pressures and increasing downtime costs.
Cracking most commonly occurs under dynamic loads and is caused by failures in the microstructure of the material.
Our solution for this problem: G.AL® DYNAMIC!
Our range of G.AL® DYNAMIC Plates:
G.AL® C210 DYNAMIC
Special products (alloy EN AW-5083) for applications under dynamic loads – free of microporosity
G.AL® C210 DYNAMIC
G.AL® C330 DYNAMIC
higher strength DYNAMIC type (alloy EN AW 7021) for pneumatic und hydraulic applications
G.AL® C330 DYNAMIC
The significantly improved elongation of G.AL® DYNAMIC protects components against cracking and – due to the absence of internal stresses – the machining times can be reduced significantly by using G.AL® DYNAMIC cast aluminum plates in:
- Mold making
- Fluid industry
- Vacuum technologies
- X-ray and medical engineering
- Laser technology
- Mechanical engineering and jig making
